Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
ifenslave [2016/04/27 14:31] steve |
ifenslave [2016/04/27 14:37] steve |
||
---|---|---|---|
Line 8: | Line 8: | ||
* [[ip]] | * [[ip]] | ||
- | * [[https://www.kernel.org/doc/Documentation/networking/bonding.txt|Linux Ethernet Bonding Driver HOWTO]] | + | * [[https://www.kernel.org/doc/Documentation/networking/bonding.txt|Linux Ethernet Bonding Driver HOWTO]] - kernel.org |
+ | * [[https://wiki.debian.org/Bonding|Debian wiki entry]] | ||
The ''ifenslave'' program is used to set up bonding for network devices. This must be used in conjunction with support for bonding in the Linux kernel. | The ''ifenslave'' program is used to set up bonding for network devices. This must be used in conjunction with support for bonding in the Linux kernel. | ||
Line 37: | Line 38: | ||
The new device name is ''bond0'', and can be set as normal using ''ifconfig'', ''ip'', ''ifup'', etc. | The new device name is ''bond0'', and can be set as normal using ''ifconfig'', ''ip'', ''ifup'', etc. | ||
+ | |||
+ | Check the bonding interface: | ||
+ | |||
+ | <code> | ||
+ | cat /proc/net/bonding/bond0 | ||
+ | </code> |