Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
gentoo_networking [2015/07/28 11:05] steve |
gentoo_networking [2016/04/27 14:29] steve |
||
---|---|---|---|
Line 15: | Line 15: | ||
<code> | <code> | ||
ls /sys/class/net | ls /sys/class/net | ||
+ | </code> | ||
+ | |||
+ | === Bonding === | ||
+ | |||
+ | Install [[ifenslave]] package to set up bonding. Also make sure your kernel has bonding enabled, or the ''bonding'' module is loaded. | ||
+ | |||
+ | A basic configuration in Gentoo, where the IP address is set manually. | ||
+ | |||
+ | The bonding interface uses the mac address of the first slave ethernet device listed. | ||
+ | |||
+ | Edit ''/etc/conf.d/net'' | ||
+ | |||
+ | <code> | ||
+ | # Don't initialize any of the interfaces by default | ||
+ | config_eth0="null" | ||
+ | config_eth1="null" | ||
+ | |||
+ | slaves_bond0="eth0 eth1" | ||
+ | mode_bond0="1" | ||
+ | miimon_bond0="100" | ||
+ | config_bond0="192.168.1.2" | ||
+ | routes_bond0="default via 192.168.1.1" | ||
</code> | </code> |