Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
gentoo_networking [2015/07/28 11:05] steve |
gentoo_networking [2016/04/27 14:28] steve |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| <code> | <code> | ||
| ls /sys/class/net | ls /sys/class/net | ||
| + | </code> | ||
| + | |||
| + | === Bonding === | ||
| + | |||
| + | Install [[ifenslave]] package to set up bonding. Also make sure your kernel has bonding enabled, or the ''bonding'' module is loaded. | ||
| + | |||
| + | A basic bonding configuration in Gentoo, where the IP address is set manually. | ||
| + | |||
| + | The bonding interface uses the mac address of the first slave ethernet device listed. | ||
| + | |||
| + | Edit ''/etc/conf.d/net'' | ||
| + | |||
| + | <code> | ||
| + | # Don't initialize any of the interfaces by default | ||
| + | config_eth0="null" | ||
| + | config_eth1="null" | ||
| + | config_eth2="null" | ||
| + | config_eth3="null" | ||
| + | |||
| + | slaves_bond0="eth0 eth1 eth2 eth3" | ||
| + | mode_bond0="1" | ||
| + | miimon_bond0="100" | ||
| + | config_bond0="192.168.1.2" | ||
| + | routes_bond0="default via 192.168.1.1" | ||
| </code> | </code> | ||
