Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
bonding [2016/04/26 17:45] steve |
bonding [2016/04/27 14:29] steve |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| * [[Networking]] | * [[Networking]] | ||
| + | * [[Gentoo Networking]] | ||
| * [[Ubuntu Networking]] - contains example about bonding | * [[Ubuntu Networking]] - contains example about bonding | ||
| * [[ifenslave]] | * [[ifenslave]] | ||
| Line 15: | Line 16: | ||
| <code> | <code> | ||
| cat /proc/net/bonding/bond0 | cat /proc/net/bonding/bond0 | ||
| - | </code> | ||
| - | |||
| - | === Gentoo === | ||
| - | |||
| - | A basic bonding configuration in Gentoo, where the IP address is set manually. | ||
| - | |||
| - | The bonding interface uses the mac address of the first slave ethernet device listed. | ||
| - | |||
| - | Edit ''/etc/conf.d/net'' | ||
| - | |||
| - | <code> | ||
| - | # Don't initialize any of the interfaces by default | ||
| - | config_eth0="null" | ||
| - | config_eth1="null" | ||
| - | config_eth2="null" | ||
| - | config_eth3="null" | ||
| - | |||
| - | slaves_bond0="eth0 eth1 eth2 eth3" | ||
| - | mode_bond0="1" | ||
| - | miimon_bond0="100" | ||
| - | config_bond0="192.168.1.2" | ||
| - | routes_bond0="default via 192.168.1.1" | ||
| </code> | </code> | ||
